Recent content by horse.collier

Thanks. Fully understood.

Reading an article and under the photo were the settings. The aperture was f8 and the person stated they had stopped down by 2 stops. Does that mean it was 2 stops from f16 to f8 to get the exposure he wanted? Or to take the picture he stopped from f8?

Thanks Luke

Cheers

Thank you.

I normally do down load them all but just wanted to check a few specific photos. Hard lesson learnt. Will have a look round for Scan disk recovery. None of the pics were that important as I am still getting used to my new camera so most were just trial shots.

Been browsing through my Scan disk extreme pro card and started to save photos and deleting others a few at a time. After moving about 20 photos to a new folder on my pc, went to look at the others to find every single one.....about 400 plus had been wiped. I didnt delete any folders just...

That's what I had read and just wanted it confirmed by others. Thank you

I have read conflicting statements on using an FTZ and a z mount 1.4 converter. Some say it works, where others say that it doesn't due to connectivity issues. Camera i am using is the z6iii

Already told them all the details. The bit in inverted commas comes from Nikon. Going to send it in anyway.

Received this from Kenro In order to use the MF18 with the Z series it needs to have firmware version 12-9 installed. The Z6III however, still does not appear on the compatibility chart as per the reply from Nissin below. ‘the Nikon Z6III camera has not yet been tested, or is currently...

Cheers Steve. How much was it?

Cheers. Have tried but will send them another email. On the plus side it will help sharpen up my manual flash experience lol

According to the websites I have looked at, there is no user compatibility connections and has to go to a Nissin approved centre, and I can't find one.

Can someone tell me where I can send my Nissin MF18 Macro ring flash to get the firmware updated so it is compatible with my Z6iii. I know it can be used in manual mode on, but would like the TTL function working. Thank you