I recently purchased the RT-32N module for use with the Sekonic L-358 light meter. The module allows you to trigger the Pocket Wizards (PW's) wirelessly instead of using a sync cord.
The links below provide the information required to set them up. It isn't so straight forward unless you have the information listed in the links.
It took me a good 30 mins to find the relevant info. I hope the links assist you with setting up your kit.
Ch-1 on the Sekonic is also Ch1 on the PW's
Ch-2 on the Sekonic is also Ch2 on the PW's
Ch-3 on the Sekonic is also Ch3 on the PW's
Ch-4 on the Sekonic is also Ch4 on the PW's
The issue I had was not confirming the channel on the Sekonic after selection. This is done by holding the mode button down and turning the jog wheel a further click round to the right . This writes the selected channel into memory.
http://www.sekonic.com/Products/L-358/Documentation.aspx
http://www.sekonic.com/downloads/L-358_English.pdf Page 28
The links below provide the information required to set them up. It isn't so straight forward unless you have the information listed in the links.
It took me a good 30 mins to find the relevant info. I hope the links assist you with setting up your kit.
Ch-1 on the Sekonic is also Ch1 on the PW's
Ch-2 on the Sekonic is also Ch2 on the PW's
Ch-3 on the Sekonic is also Ch3 on the PW's
Ch-4 on the Sekonic is also Ch4 on the PW's
The issue I had was not confirming the channel on the Sekonic after selection. This is done by holding the mode button down and turning the jog wheel a further click round to the right . This writes the selected channel into memory.
http://www.sekonic.com/Products/L-358/Documentation.aspx
http://www.sekonic.com/downloads/L-358_English.pdf Page 28