What is the best safest way?

Wheels

Julian Keeler
Messages
2,812
Name
Julian
Edit My Images
No
We are planning on visiting a butterfly house this week, I was wondering what is the best way
to get the camera and lens acclimatised to the humidity in there? Last time we went in 1 I just got the camera out of the bag and it misted over immediately. Is it best not to take the camera in full stop? Will it cause any damage to the camera or lens?
 
Lo Jules

Same thing happened to me, just cleaned it off and had a look around till it was clear again (about 15mins), where you going, Bolton or Lancaster.

its happened a lot when were been on holidays, in hot countries, I just usually sit on the balcony with the camera, or go for breakfast usually acclimatised by then
 
If theres going to be a big jump in temp and humidity best to put the gear in a sealed plastic bag and let it acclimate first. I ruined an Olympus prosumer cam not doing this years ago when water vapour appeared between the lens elements. I dried it out but the damage was permanent.

If its just fogging the front element a little cleaning with an anti fog spray can help.

BTW it will partly depend on the gear, sealed pro gear will handle it better but still be careful.
 
Last edited:
Warm up the camera. I just put it in the passenger footwell on the way (don't roast it!) then keep it warm in a plastic bag until you're inside.

I once used a warm air hand drier in the loos, but be careful.
 
Had this problem at the RHS Wisley earlier this year, when the outside temperatures were quite low - and the only solution was to stand in "photographers corner" at the entrance for about 15 minutes! No worse problems than people with glasses had though. Worst bit is you think its all ok, then things fog up again...

tbh, you aren't going to be able to achieve anything like the humidity levels inside a large glasshouse in your car, so i'm not convinced the plastic bag trick people mentioned will help much, but every little bit may help.

Its probably more important to worry about what happens AFTER your trip - electronics and humidity are not the best mix, so probably good idea to strip your camera and lens apart and store with silica gell for a few days after. (stick this in the oven for a little bit to dry out beforehand).


I think the wait can be worthwhile though...


_IGP5854.jpg by FTS Photography, on Flickr
 
I wouldn't worry about it. Condensation forms on cold surfaces so give your gear time to warm up. You could put it in a sealed plastic bag but I have never bothered and have had no problems. You will notice that metal bodied lenses take longer to warm than plastic. This can take 30mins or so. If you ask they may have somewhere inside the hot house where you can leave the gear to equilibrate.
Personally I would not strip your gear down after your visit. The condensation that forms on the outside of your gear is due to the continual passage of moist air over the cooler equipment surfaces. When you leave, the surroundings are cooler than your equipment and therefore draw moister away from them. The tiny amount of air within your camera will be of little significance.

HTH
 
Back
Top