- Messages
- 524
- Name
- MARINO
- Edit My Images
- No
Once again i summon the film gurus in an effort to solve an issue that’s been a pain when printing in the darkroom.
How to keep the dev temp steady in the tray??
I’ve used a aquarium heater but it was big, then bought a smaller one but it took over one and a half hour to heat up to temp and the temperature was not steady…
The tray I’m using is for 8x10 prints.
It’s a pain because it’s a race against time to keep the temp up. Once the dev temp decreases then the exposure on the paper is not the same even with the same time.
Any suggestions??
Thx
How to keep the dev temp steady in the tray??
I’ve used a aquarium heater but it was big, then bought a smaller one but it took over one and a half hour to heat up to temp and the temperature was not steady…
The tray I’m using is for 8x10 prints.
It’s a pain because it’s a race against time to keep the temp up. Once the dev temp decreases then the exposure on the paper is not the same even with the same time.
Any suggestions??
Thx