Bought this product last week, http://www.stableimaging.co.uk/index.php?main_page=product_info&products_id=37
Tested it a few days ago and it seemed to do the job very well.
Tested it further today for a longer period (only around 20 minutes) and it suddenly stopped working. Checked the snyc cable, power leads etc, and they were all fine.
After around 4 minutes it worked once then stopped again, few minutes later it did the same.
At this point i considered overheating but after only 20 minutes use that seemed a little far fetched.
I tested it using the test button on the back of one of the light units and it worked perfectly everytime. Pressed the test button and all the lights fired, again a second or so later for about 6 or 7 tests and they were fine.
Camera off, leads disconnected, reconnected, camera back on and nothing.
Im not sure whether its the lights, sync lead or whatever.
Any advice helpfull and appreciated as always.
Tested it a few days ago and it seemed to do the job very well.
Tested it further today for a longer period (only around 20 minutes) and it suddenly stopped working. Checked the snyc cable, power leads etc, and they were all fine.
After around 4 minutes it worked once then stopped again, few minutes later it did the same.
At this point i considered overheating but after only 20 minutes use that seemed a little far fetched.
I tested it using the test button on the back of one of the light units and it worked perfectly everytime. Pressed the test button and all the lights fired, again a second or so later for about 6 or 7 tests and they were fine.
Camera off, leads disconnected, reconnected, camera back on and nothing.
Im not sure whether its the lights, sync lead or whatever.
Any advice helpfull and appreciated as always.