I have bought an Epson 2400 off eBay but am having trouble with it.
I have not managed to get a single decent print from it. It was purchased needing one cartridge which I bought and ran the head clean print alignment utilities. It then ran out of ink in one of the other cartridges. So I replaced this cartridge and repeated thehead clean/alignments. After this more cartridges ran out. So I replaced all the carts I had not already replaced. On replacing all the new carts I again ran the clean and align tools but it still would not print quality. The test print had patches in it's grid. I tried printing a couple 6*4 but these had lines and were grainy in places. And now it is reporting low ink
If you are still reading this you will understand my frustration... Lol
Any advice?
do the carts really run out after less than 10 prints and a few cleans
I know a CIS is the way to go but I wanted to ensure it was fully working before spending money on one
Is it knackered
I have not managed to get a single decent print from it. It was purchased needing one cartridge which I bought and ran the head clean print alignment utilities. It then ran out of ink in one of the other cartridges. So I replaced this cartridge and repeated thehead clean/alignments. After this more cartridges ran out. So I replaced all the carts I had not already replaced. On replacing all the new carts I again ran the clean and align tools but it still would not print quality. The test print had patches in it's grid. I tried printing a couple 6*4 but these had lines and were grainy in places. And now it is reporting low ink
If you are still reading this you will understand my frustration... Lol
Any advice?
do the carts really run out after less than 10 prints and a few cleans
I know a CIS is the way to go but I wanted to ensure it was fully working before spending money on one
Is it knackered