t
But in basic, if i want to use F10 for a shot and the expo meter is saying 1/60 shutter, at iso 100, i can then lift the iso to 200 to give me a shutter of 1/120 or 1/125 as i think it is, which then allows me to go hand held better, or iso 400 and get 1/250.
or using the same base f10,1/60, iso 100 i could drop the aperture down to f9 and that will allow 1/120 shutter or f8 would allow 1/250, if i was still not happy, i could lift the iso to 200 and then that would allow f9 @1/250 or F8 @1/500 shutter.
Your principle is correct yes, if you change one of the three settings to allow one stop more light (e.g. ISO from 100 to 200) that will allow you to change one of the other ones to allow one stop less light (e.g. shutter speed from 1/125 to 1/250) while keeping the same exposure. Or if you change two of them to allow one stop more light each (e.g. ISO from 100 to 200 and aperture from f/8 to f/5.6) that would allow you to set the remaining one to allow two stops less light (e.g. shutter speed from 1/125 to 1/500).
Careful with the numbers though, f/10 to f/9 is only a third of a stop while 1/125 to 1/250 is a full stop.
One click of the dial on a DSLR is 1/3 of a stop, so three clicks is one stop. The easy way to do it is count the clicks but you can then get lost if you slip or forget how many clicks you made on one of the settings.
I'd imagine your camera is the same but it's possible it works in halves rather than thirds, if it works in halves it would be two clicks for a full stop of light difference rather than three clicks.
ISO is easy because the number doubles or halves and that is one stop, e.g. 200 is one stop more light than 100.
The ISO scale in full stops is like this:
100, 200, 400, 800, 1600, 3200, 6400, 12800
Shutter speed is easyish because the number doubles or halves to be one stop, e.g. 1/125 to 1/250 is one stop less light, but the camera does some rounding off. As you've noticed 1/60 should double to 1/120 but the actual number available is 1/125, this happens a few times in the shutter speed scale.
The shutter speed scale in full stops is like this, " means full seconds:
30", 15", 8", 4", 2", 1", 1/2, 1/4, 1/8, 1/15, 1/30, 1/60, 1/125, 1/250, 1/500, 1/1000, 1/2000, 1/4000, 1/8000
Aperture is more awkward because it has rounding off and a one stop difference is actually x1.41421356 (x1.4 and round up a bit should get you close enough) rather than doubling.
The aperture scale in full stops of light is:
1.0, 1.4, 2.0, 2.8, 4, 5.6, 8, 11, 16, 22 and so on.
Then between all these full stop values you get the thirds or halves of a stop, for example between ISO 200 and 400 you get ISO 250 and 320.
Exposure compensation is fairly straightforward as it just changes what the camera meter tells you is correct.
If you point the camera at something and it gives you 1/250 f/5.6 ISO 400 with no exposure compensation then with +1 exposure compensation it will try to record one stop of extra light so it would change one of the exposure settings by one stop.