It's simple. Big box of cereal and a ruler at 45* leaning against the side. Make sure the light is good and you defocus every time. Check each lens several times.
The minimum distance thing is relevant, but if you use a certain lens much closer very often it's worth checking at that distance, but be aware it may throw you're general focus out a little.
Yes, I have posted this pic a few times before
Set it up square and AF on the box near the ruler, then see where the focus has actually landed on the ruler, and adjust.
Having done this a few times now, the 50x focal length distance thing is poor advice frankly. It makes the test distance change too much depending on the lens, and of course format alters how different focal lengths are actually used.
All I would say is avoid the very close distances that are suggested with some targets, which naturally push the lens right to the edge of its operating envelope. The result being that it introduces errors, or exagerates them, and when you correct those the lens is then out of optimum at normal shooting range. Just use a sensible, normal close-ish working distance as you might in practise.
I have also found this particular method quite tricky with wide angles where the large depth of field makes it hard to see where the sharpest point actually is. Same applies to longer lenses if you want to check them at more distant settings (as you might probably use them).
A better method for them is to stick a page of text from a magazine to a wall. Then shoot pictures with the AF microadjust at the full range of settings, from -20 to +20 at increments of five. See which one is sharpest with the 10x magnification on the LCD (if you have a good big LCD, otherwise on the PC) then repeat and fine tune around that. Remeber to de-focus between each shot, and double and treble check everything to esnure you're correcting a consistent error and not just a one-off bad shot.