Shutter speed Photos so bright as in white

Messages
504
Name
Zoe
Edit My Images
Yes
Went to take some shots of a lake yesterday and was having a play with S settings. All the long shutters came out white. i tried all different shutter speeds but they all were the same.

Spoke to a friend of mine who is a photographer and he asked me to send him one of the shots, he said it was because i was shooting on F22. I did notice this but i could not change the F on the cam? I am using the Olympus E420

Can anyone advise me on what i am doing wrong? My friend said it would be better for him to show me rather than tell me on net, But i am impatient and want to take more shots of this place:help::help::help:
 
It should be irrelevant what aperture value you're shooting on. Bright white is a clear overexposure.

Check your exposure bracketing modes, and I would recommend shooting in manual mode to get the correct exposure you want, and then swapping over to S mode and seeing if you get the same exposure time (roughly).
 
It should be irrelevant what aperture value you're shooting on. Bright white is a clear overexposure.

Check your exposure bracketing modes, and I would recommend shooting in manual mode to get the correct exposure you want, and then swapping over to S mode and seeing if you get the same exposure time (roughly).

Hi thanks for replying... I am not sure how to chk Bracketing modes :|

When i set it to A Mode pics were fine... Oh And my ISO was set at 100...

Will have a play laters

Zoe
 
Is it that your exposure time was too long and that the aperture was not able to close down enough to get a proper exposure?
 
he said it was because i was shooting on F22

Are you sure he's a photographer ??? That's a rather silly comment tbh

Next time, use Av mode and a high f-stop (such as f22) and see what shutter speed it's giving you at that f-stop. If it was a sunny day you might have f22 and 1/125th second, so going slower than that is highly likely to turn everything 'white' due to being overexposed

As a test though, take a reading in Av mode at f22 and note the shutter speed - then switch to S mode and set that shutter speed you've just read, and the camera should set the same aperture. If it doesn't something else is wrong and you may well need a mate to see it hands on

HTH

DD
 
i just replicated what you did on my nikon

to long an exposure and it goes wight i also had a warning...high

that is i set a vely slow shutter speed

i much prefer aperture priority as i know opening up increases shutter speed and stopping down gives more depth so i can still get fast shutter speeds when needed.

you dont get the wrong exposure either ive never had it go wight in aperture priority

keep experimenting its a good way to learn :)
 
F22 is the smallest aperture on the oly kit lens - So you must have had a shutter speed so long that even closed down to its smallest setting the camera was getting too much light.

Could we ask what shutter speed you were using and what you were trying to achieve? Were you trying to get those flowing water shots? If so then the way to do it is to use an ND filter on the lens - in effect a piece of smoked glass that cuts down the amount of light getting into the camera. That allows the long shutter speeds without burning out the image.
 
F22 is the smallest aperture on the oly kit lens - So you must have had a shutter speed so long that even closed down to its smallest setting the camera was getting too much light.

Could we ask what shutter speed you were using and what you were trying to achieve? Were you trying to get those flowing water shots? If so then the way to do it is to use an ND filter on the lens - in effect a piece of smoked glass that cuts down the amount of light getting into the camera. That allows the long shutter speeds without burning out the image.

:agree:

Or to save money - go on a duller day :)

DD
 
its simple you had it on to long a shutter speed [ so exposure was wrong] increase the shutter speed and set the lowest iso speed [you should have warnings ]

better still shoot on aperture priority and set the highest aperture no ie f22 the camera will select the correct exposure use a tripod it will be the correct exposure then
 
Dull day, f22, ISO 100.

A shutter speed of 1/4 to 1/8 should be about right. Any longer and you will start to over-expose. Much longer and you will get lots of white.

Could you have confused 4 with 1/4 ? (or whatever speed you wanted 2 to 1/2, 8 to 1/8, etc.)




Steve.
 
Dull day, f22, ISO 100.

A shutter speed of 1/4 to 1/8 should be about right. Any longer and you will start to over-expose. Much longer and you will get lots of white.

Could you have confused 4 with 1/4 ? (or whatever speed you wanted 2 to 1/2, 8 to 1/8, etc.)




Steve.

Ok great. Think i will go back to A mode for now. Its raining might get out later to take some more shots ***:)
 
Awwww. I am all confused

The camera can adjust the ISO sensitivity and aperture to get the correct exposure at the shutter speed you desired. At f22 the lens is letting in as little light as it can, and the ISO was probably as low as it could go, so the camera can't be any less sensitive to light. You have told the camera to open the shutter for so long it is completly whiteing out the image.

Remember the shutter speed range allows for decent exposures in very low light situations at night, but then also for very heavily lit stuff, and you'll realise in daylight the range of shutter speeds you use is relatively small. Go outside of this range and the camera doesn't have enough adjustmets it can make to get the normal exposure.

If you want to use long shutter speeds when there is lots of light the you have to limit the light that enteres the camera with ND filters, which are basically sunglasses for your camera.
 
The camera can adjust the ISO sensitivity and aperture to get the correct exposure at the shutter speed you desired. At f22 the lens is letting in as little light as it can, and the ISO was probably as low as it could go, so the camera can't be any less sensitive to light. You have told the camera to open the shutter for so long it is completly whiteing out the image.

Remember the shutter speed range allows for decent exposures in very low light situations at night, but then also for very heavily lit stuff, and you'll realise in daylight the range of shutter speeds you use is relatively small. Go outside of this range and the camera doesn't have enough adjustmets it can make to get the normal exposure.

If you want to use long shutter speeds when there is lots of light the you have to limit the light that enteres the camera with ND filters, which are basically sunglasses for your camera.


I see. I have ordered a load of Filters which should hopefully come this week or next.

Ordered

Neutral Density ND2
Neutral Density ND4
Neutral Density ND8
Graduated Grey

will these be any good?
 
Can you post an image and the exif info (ie shutter speed/aperture(f -number)/iso) on here?

In 'S' Shutter mode, you set the shutter speed and the camera will select an aperture (and possibly iso) to try and get the best possible exposure of the image. This is why you couldnt alter the F number, in S mode the camera is in charge of the aperture. And as said the minimum aperture is probably f/222, that is you cant get a smaller one with that lens.

Do you understand the analogy of filling a bucket?
Taking a picture needs a certain amount of light, this is a bit like filling a bucket with water.
You can vary the shutter speed which is like how long you leave the tap running.
You can vary the aperture - how much the tap is open.
You can vary the iso - how big is the bucket.

You can see that there are lots of different ways of getting a full bucket. open the tap wide for a short lenght of time or open the tap a little for a long time.

In this case it sounds like you left the tap running for too long. The camera turned the tap down as low as it could, but the bucket still overflowed.

How does the camera try to get the exposure you might ask ? It has a built in meter to try and measure the amount of light. It has a rough idea of how much light is needed for a picture and will juggle the things that it is in charge of to try and get it right.

You can tell it to base its choices on either everything in view(multisegment), the stuff roughly in the centre of the view(centre weighted) or the exact centre (spot).
 
I see. I have ordered a load of Filters which should hopefully come this week or next.

Ordered

Neutral Density ND2
Neutral Density ND4
Neutral Density ND8
Graduated Grey

will these be any good?

Yep - the ND's will restrict the light going in - you did get the correct size for your lens didnt you?
 
Are you sure you didn't turn up the exposure compensation/EV accidentally?
 
it went wight

Strange!

Last week I corrected someone who called The Isle of Wight, The Isle of White.

You've done it the other way round!


But back to our regular programme..... With a shutter speed of 1.6 seconds when it should have been around 1/4 to an 1/8 is an increase of 2.6 to 3.6 stops. Quite a lot of overexposure but there should still be some sort of image there (what were shadows will now be highlights!).




Steve.
 
Ok just got the properties of one of the pics

F-Stop = F22

Exposure time = 1.6secs

ISO = 100

+ Sunny Day = Bright white photos

If you want to use long exposures you'll have to wait until your ND filters turn up :)
 
OK - You know what went wrong now, a too long shutter speed.

Check your camera to see if there is an indication/warning somewhere if you are setting an exposure that is too great or too small.

On Auto there should not be a problem

On Aperture priority you can only vary the aperture a certain amount according to the lens so normally there will not be a problem.

On Shutter priority however you can vary the shutter speed a lot, as you have found out, and this can easily lead to overexposed or underexposed pictures.

Have a play and see what you can do!
 
:bonk:
Strange!

Last week I corrected someone who called The Isle of Wight, The Isle of White.

You've done it the other way round!


But back to our regular programme..... With a shutter speed of 1.6 seconds when it should have been around 1/4 to an 1/8 is an increase of 2.6 to 3.6 stops. Quite a lot of overexposure but there should still be some sort of image there (what were shadows will now be highlights!).




Steve.

its called being thick or thighk must spell better...:bonk: :lol:
 
The exposure compensation button is in front of the control dial, beside the shutter. IIRC you hold this whilst turning the control dial and looking through the viewfinder. There is an indicator inside the viewfinder to tell you the setting. You may be able to do this with the menus in the lcd screen too, I know it can be done that way with the E500.
 
When in doubt I fall back on the "Sunny 16 Rule" as a starting point. The "rule" states that when shooting in bright, sunny conditions at f/16 your shutter speed should be the reciprocal of your ISO. Thus at 100 ISO your shutter speed should be 1/100 if your aperture is f/16.

f/22 is one stop darker than f/16. To balance that out you would need to lower your shutter speed to 1/50 (we're still assuming bright sunshine here) or increasing your ISO to 200 would also work.

Clearly, shooting for 1.6 seconds when you only need to expose for 1/50 seconds is going to cause a problem of overexposure by about 8 stops (in bright sunshine). In lesser light the overexposure might not be quite so bad, but you really need to consider what kind of shutter speed is realistic for the light conditions.

A neutral density filter will certainly open up more options for shooting with extended shutter speeds. Good luck :)

EDIT : Some tips for exposure metering - http://photography-on-the.net/forum/showthread.php?t=89123
 
Back
Top