You need to read the instruction book Dave. Nobody on the planet can work a new camera 100% without doing that (although plenty try

).
Quick lesson in exposure control. You need a certain amount of light for correct exposure. The brightness of everyday subjects varies massively, like at least 1,000x throughout the day, and your eye copes with this without you even noticing, but it is actually working in a similar way to a camera.
To get the right amount of light on the sensor, there are three controls. The shutter speed is one, which varies the amount of time the sensor is exposed to light. The lens aperture, expressed as an f/number, varies the size of the hole through which light passes. Then there is ISO, which varies the sensitivity of the sensor to light.
All these controls works on a halving/doubling principle, although it's not always obvious. With the shutter speed, obviously 1/250sec is half 1/125sec and so on, but also with the lens aperture f/4 is twice the light passing area of f/5.6, which is twice f/8 and so on. The relationship is the square root of 2, ie 1.4x, for historical reasons - you just have to learn them I'm afraid. Then there is ISO, where ISO200 is half as sensitive as ISO400 etc. If you think about it, 1/500sec at f/4 and ISO400, is the same effective exposure as 1/125sec at f/5.6 and ISO200.
You mix and match these controls both to vary the exposure in line with the amount of light available, and also to create effects - like a long shutter speed to blur water. A long shutter speed will allow a lot of light on to the sensor, so you have to compensate that by using a high f/number and/or low ISO. With extremes, such as a blurry waterfall in bright sun, the camera hasn't got enough scope so you need to fit something like a neutral density filter over the lens, to reduce the amount of light - basically dark glasses for your camera.
Tip: most people set the ISO and pretty much leave it there, and adjust exposure using just shutter speed and f/number. Only adjust the ISO when you've run out of options on the other controls. Try ISO400
Edit: you will hear people talk about 'stops' - one stop is any halving or doubling of exposure (another historical term). The difference between f/4 and f/5.6 is one stop, 1/125sec to 1/500sec is two stops, ISO200 to ISO1600 is three stops, and so on.