Any advice on photographing Steam Trains

get close for that fascinating era where machines were built by candlelight and engineering was inch by thick
some steam in the shots adds flavour
and the colours
details
high vantage viewpoints good for moving trains
going right to left gives the most satisfying read...we read left to right so your eyes start at the engine
wish i was there
the season is ending soon
 
Dont stand on the track :lol:

sorry
 
Platforms will probably be crowded with other photographers and assorted steam enthusiasts all trying for the same shot. Maybe try waiting near the track so you can catch the locomotive as it's arriving slowly? You could then try to run round to the far end and catch it again as it's leaving.

Head on looks good, staring straight at the smokebox door, The valve gear and other rods around the wheel look good too, as does the pipework. If you do find a prime spot on the platform, a shot into the firebox, showing the flames. The interior of the cab with grimy fireman and shiny piopes. The steam escaping as the whistle blows.
 
You do not need to go to a station where it will stop. Find out the route and times, then find a suitable vantage (bridge; embankment; though station). It will be less crowded than at a main station.

If you wait at an incline there could be more steam from engine as it will be working hard. On a down slope it is likely there will be no steam from funnel. Another good time for steam is when the engines are pulling out of the station.
 
If there's a small signalbox nearby, most signallers can be partial to a bacon butty and will allow you to shoot from their windows or stairs for a good vantage point. They'll give you a tour of the box workings in most cases too .. good photo opportunities ;)
 
Grads could be a good idea, as burnt out skies are often a problem due to the camera exposing for the large dark object that is a steam engine. It might also retain some detail in the steam, providing there is some - you don't always get that much when it's warm weather.

Don't use a polariser, it will darken the whole image, and you'll likely lose detail in the engine. For moving engines, I tend to use 1/250, maybe up to 1/500 if I'm standing pretty close for something like this, although this depends on the speed of the train of course.

Personally, I find that getting some landscape in the picture always makes for a more satisfying image, unless you're a 'rivet counter' and like taking pictures in stations.
 
Back
Top