Best way to change size and ratio of a photo?

Messages
2
Edit My Images
Yes
I want to end up with an image for a CD cover (doubled up). The dimensions need to be 248 x 126 mm. My camera doesn't take shots with this ratio, so I was wondering what the best way to do this is. I have Photoshop CS and mpeg Streamclip and I'm using a Mac G5 PPC.

This is not just resizing I want here as I also need to change the ratio of the shot
 
Cropping or matting/masking would be the most obvious ways.
 
Start off by cropping the sides image so that it has on it the bits that you want to have on the CD cover. Now resize the image so that it is 300dpi and 248mm wide. Now crop the bottom of the image to show how you want it to appear on the CD. Finally resize the Canvas to 126mm, biasing the resize in favour of the bottom edge. You should end up with the image that want in the correct size at a suitable resolution for printing.
 
Why not just set the crop to: width 248mm, hight 126mm, resolution 300 dpi?
 
you can do this stuff in word (windows)/ other cd making software?
 
you can do this stuff in word (windows)/ other cd making software?

This will vary with the programme. The more sophisticated ones will allow you more control, but will need a bit more learning. Dunno about word, but any of the Photoshop and similar programmes allow you to do what you want.

If you put up a high-res image of what you want cropping, any of us can do it here for you.
 
You guys are talking about dpi when the OP needs to resize to PPI (pixels per inch).

DPI is a printer setting which you can choose from the printer driver. Epsons print at an effective 360dpi. There is no need to set your ppi to match. I see the Epson thing as a bit of a red herring really and it really doesn't affect the print quality so you can set the ppi to pretty much anything above 150ppi and still get a superb print.

The image size above is close to 10"x5". 3000x1500 pixels will be required to allow you to print it at 300ppi although if the image is smaller printing at a lower resolution will be fine.

Jon Ryan's first part is right - Use the crop tool to resize to the proper dimensions but best to leave the resolution BLANK (no need to resample unnesessarily) If the image is already very small however and won't allow you to print at around 150ppi then you may want to consider a small resample).

Regards
Jim
 
Oops! Yes, should have said PPI. :bonk:

Without seeing the image, it's hard to know if some resampling would be needed, so wouldn't setting a resolution be a good thing `in case`?
 
Last edited:
Oops! Yes, should have said PPI. :bonk:

Without seeing the image, it's hard to know if some resampling would be needed, so wouldn't setting a resolution be a good thing `in case`?

Not really although you're right that without knowing the size it "could" be required. Also depends on who prints the image as your pro lab RIP software will resample better than anything you can do in Photoshop or any other consumer software package.

To print a quality 10x5 you only require around a 1500x750 pixel image so not very big and you could probably get away with less. So it's rare that resampling should be needed for many images (although some are obsessed with the 300ppi figure).

Smugmug use pro labs around the world and they print pro high quality 30" prints at down to 80ppi!!!
http://help.smugmug.com/customer/portal/articles/93359

If you have the pixels, then 300ppi is perfect
 
Back
Top