- Messages
- 28
- Name
- David
- Edit My Images
- Yes
Hi. Just obtained a Bowens Gemini 1500 Pro. Arrived with modelling lamp not installed sent in its original carton. Installed now but the two fuses that came with have both blown when at the end of the session I have fired of a couple of full power flashes and then quickly turning the power off. Not sure of the exact science behind this but when my D750 Pro went weird I was told by the repair people I should carry out this operation after each session. Quite intense with 1500ws.
Have also read about the modelling lamp blowing the fuse but I very rarely use and certainly not when emptying the tubes.
Anyway….. after much research I’ve been unable to find any info into the correct amp fuse required.
However the manual states 20mm fuses (that’s all).
Anyone who could advise would be greatly appreciated.
Just bought these as some as someone was selling fuses a £3.50 a shot not including postage. As there was no tech info included gave it a miss. These appear to have the required dimensions but would like to be sure about which amp before installing.
Have also read about the modelling lamp blowing the fuse but I very rarely use and certainly not when emptying the tubes.
Anyway….. after much research I’ve been unable to find any info into the correct amp fuse required.
However the manual states 20mm fuses (that’s all).
Anyone who could advise would be greatly appreciated.
Just bought these as some as someone was selling fuses a £3.50 a shot not including postage. As there was no tech info included gave it a miss. These appear to have the required dimensions but would like to be sure about which amp before installing.
Attachments
Last edited: