Cold to Warm or warm to very hot

  • Thread starter Thread starter Animal
  • Start date Start date
A

Animal

Guest
ok, this has puzzled me a few times when I've done this..

for example going from normal temperature into a building say a butterfly house, and the camera steams up both on the lens, screen and view finder.. after cleaning and cleaning the camera finally gets to the temperature to save having to do it..

How can you do this without having to de mist the lens and sometimes even the mirror..
thanks
 
They only real way it to slowly bring the camera to the same temperature as in the new room you are entering. The best way I find is to put the camera in your bag before you go in and don't get it out until your sure the camera temperature is at the same as the new room.

All good and well in some circumstances but I know this is not always possible.


Matt
 
as long as it doesn't damage the camera, will keep trying different methods, other option is just stop going - lol
thanks
 
if there is a loo close by, gently warm up the body under the hand dryer.:wave:
 
i have this problem a lot doing club photography and moving from outdoor smoking areas into hot sweaty clubs

as for how to ease it, I am not yet sure. i'd be interested in hearing what others have to say about it...it usually takes my camera 5-10 mins to adjust. i tend to now leave it behind the decks or somewhere safe in the club rather than take it outside, unless i intend to take pictures there
 
No - because the dryer is blowing dry air, the room you are entering has high humidity as well as heat - hence the steaming up
 
Can't help with the mirror, but you could try two UV filters.
(assuming you want to keep a filter on your camera for protection).
I only used 1 UV filter, but recently I found the same problem.
My bag was keeping really cool, after being in air-conditioned areas, and even after taking the camera out outside, using it, then putting it back in the bag, it was cooling down and having the condensation problem again when I removed it (even if I hadn't re-entered a cool building).
However, for me, and your mileage may vary, I was only getting condensation on the outer plate of glass.
I.e., take camera out, wait 10 seconds for a thick fog of condensation, then remove UV filter, attach lens cap to filter, put in shirt pocket. Front element of the lens itself stayed OK after removing the filter.
Not sure why, as (after a night in an air-conditioned room it would be) it would have been as cold as the UV filter itself, there was no visible issue.
 
Back
Top